• Cutting with rotating roll mounted blades
• Hard polyurethane counter roll
• Mat sampling during operation
• Very low blade and counter-roll wear
• Precision cutting
• No production waste
• Cutting with rotating blades and counter-blades
• Inverter-controlled cutting speed
• Cutting width may be set during operation
• No. of cutting at customer request
• Low blade wear
• Minimal production losses
• Easy operation & maintenance
• Calenders and pulling rolls designed with closed tolerances
• Two calendering systems (three on request)
• Simple lay-out
• Perfect synchronization
• Minimal stress and mat breaking
• Easy operation and maintenance
• Modular design
• Independent heating system for each section
• Air distribution control inside the oven
• Flexible drying system and optimal drying process
• Easy cleaning and maintenance
• Separate belts for emulsion and powder binders
• Emulsion binder deposition quantity by overflow & suction fan
• Optimal binder distribution
• Emulsion binder: obstruction-free pipes and/or nozzles
• Fiber distribution with rotating devices
• Air distribution fitting
• “Snow effect” fiber dropping
• Optimized fiber distribution
• Profile control for reduced fiber waste at mat edge
• Minimum 20 chopper units (no. of units according to production rate)
• Chopper speed regulated independently and synchronized by inverter
• Range of strand cutting lengths
• Production of lightweight mat
• Optimal fiber distribution
• High operating flexibility
